Fiber Optic Cables

ADSS Fiber Optic Cable

ADSS (All-Dielectric Self-Supporting) optical fiber cable is a non-metallic cable that supports its own weight without the use of lashing wires or messenger cables. The installation is achieved in a single pass, making ADSS an economical and simple way of building an optical fiber network.

Air Blown Microduct Fiber Optic Cable

Air blown microduct fiber cable is optimised for injection into microducts and is used in optical networks, more specifically for use in Fiber-to-the-home (FTTH) and Fiber-to-the-Desk (FTTD) networks. This technique that is lower at cost, quicker and more environmentally friendly than traditional deployment, allowing a simpler instalation with less resources.

Indoor/Outdoor Fiber Optic Cable

Indoor/Outdoor fiber optic cable is prepared for both environmental requirements, indoor and outdoor optical networks, which can be run in duct, direct buried or aerial in the outside plant. By installing this cable, there's no need of costly splice junctions when entering into buildings because of the adaptability of the cable.

Duct Fiber Optic Cable

Conduit cables are underground cables, that may be conducted by duct or buried directly into the ground. There are several types of protections for this cable such as anti-rodent or double protection. Conduit cables are built to withstand harsh environments and are typically routed by pull or blow.

Direct Buried Fiber Optic Cable

Direct buried cable is optimised for injection into ducts in optical networks and is usually directly buried or installed in ducts by air-blowing, jetted, pulled or pushed into the duct.

See All Fiber Optic Cables Products

See All
Telco Marketplace
Telco Marketplace
Save Time
Save Time
Save Money
Save Money
Safe Shopping
Safe Shopping